How to Change the Oil on a 2024 GasGas ES 500 (DIY Step by Step)

Right side engine cases of a 2024 GasGas ES 500 on the stand for an oil change

I hit 291 miles on the ES 500 and rode it a little rough in the beginning, out on trails with Arthur, Tim and Eli. Time for the first oil change. It’s an easy job you can do in the garage and save yourself the shop bill. Here’s exactly how I did it.

The full oil change in three minutes.

What you need

  • Maxima Pro Plus oil
  • OEM KTM oil filter (same filter fits the GasGas)
  • A ratchet with a deep socket for the drain plug
  • A T30 Torx for the oil screen and filter cover
  • A drain pan and some rags

I grabbed the oil and filter at Rocky Mountain ATV/MC since they’re close by, but both are on Amazon too.

Socket set and T30 driver in the toolbox for a dirt bike oil change
Socket, T30 and you’re basically set.

Step 1: Warm it up

Run the bike for 30 seconds to a minute. Warm oil drains faster and carries more of the junk out with it.

Warming up the GasGas ES 500 in the garage before draining the oil

Step 2: Pull the oil screen and drain plug

Use the T30 to pull the oil screen out of the bottom of the engine, then pull the drain plug on the right side with the socket and let it all drain. My screen had some little metal bits in it. Arthur says that’s normal on a fresh engine, but keep an eye on it on future changes.

Step 3: Swap the filter

The filter lives behind the cover on the right side, held on with T30 bolts. Pull the cover and the old filter out.

Removing the oil filter cover on a GasGas ES 500

Little trick: the manual has you lean the bike over to the right so you can prefill the filter housing. Skip that and just soak the new filter in fresh oil before it goes in.

Step 4: Button it up and fill

Reinstall the screen, drain plug and filter cover. The manual lists torque specs for all of these. I hand-tightened mine, but if you have a torque wrench, use it, these are small bolts going into aluminum. Fill with fresh oil and check the sight glass on the side of the engine. You want it about halfway.

Right side engine cases of a 2024 GasGas ES 500 on the stand for an oil change
Done. Check the sight glass for about halfway.

And that’s how you change the oil on a 2024 GasGas ES 500. Same process works on the KTM and Husqvarna 500s. If you’re still deciding on the bike, here’s my ES 500 first impressions.

Some links are affiliate links. I may earn a small commission at no extra cost to you.