BikeRiser Wall Mount Install: Getting the Bikes Off the Garage Floor

Mountain bike hanging on a BikeRiser wall mount in a finished garage

Heads up: BikeRiser sent me these two mounts for free. They didn’t pay for this post or see it before it went up. Some links below are affiliate links, so if you buy through them I may earn a small commission at no extra cost to you.

The garage is basically done. Epoxy floor, paint, lights, all of it. If you missed that one, here’s the DIY flake epoxy garage floor post. The one thing that kept bugging me was the bikes. They were just leaning on the wall, scuffing up the fresh paint every time somebody moved them. So this is episode 2 of the garage upgrades: getting the bikes up on the wall.

Why BikeRiser

BikeRiser mounts hold the bike by the pedal, so the bike sits flat against the wall instead of hanging off a hook by the wheel. That keeps it tight to the wall and out of the way, which is exactly what I wanted in a garage that also has to fit a Jeep and a dirt bike. You can check them out on the BikeRiser site.

BikeRiser bike wall mount box and hardware laid out before install

What’s in the box

  • The pedal hook, with a foam pad so it doesn’t chew up your pedal
  • L brackets for the tire support
  • Drywall hardware if you can’t hit a stud for the lower pieces
  • Three mounting points that go into the stud for the main bracket

Tools I used

BikeRiser says install takes under 5 minutes. Honestly it was more like 10 per mount for me, which is still nothing. Most of that is just measuring and leveling.

How I installed it

  1. Find the stud. The main bracket needs to go into a stud. Run the stud finder and mark it.
  2. Hold the bike up and mark the pedal. Lift the bike to the height you want and mark where the top of the pedal lands on the wall.
  3. Level the bracket. Line the bottom of the bracket up with that mark, put the level on it, and get it straight before you drill.
  4. Drill and mount. Pilot holes, then the three screws into the stud.
  5. Mark the tires. Put the bike on, see where the tires fall, and mark that spot for the tire support. Mount the L bracket there.
Leveling the BikeRiser pedal bracket on the garage wall before drilling

The conduit surprise

My plan was to put the two bikes side by side. Then I hit metal conduit in the wall on one side. Not drilling into that. So instead I stacked them, one higher and one lower on the same section of wall. It actually works out better, because the dirt bike still fits right in front of them. Lesson here: run your stud finder wide before you commit to a layout.

Two Trek Marlin 5 mountain bikes stacked on BikeRiser wall mounts in the garage

Those are our two Trek Marlin 5s, mine and Laurin’s. Getting a bike on is easy: you roll it up, set the pedal on the hook, and pedal it into place. Off is the same thing backwards.

Close up of a bike pedal resting on the foam padded BikeRiser hook

Will it fit your bike?

  • Pedals: under about 22mm across, measured right above the threads
  • Handlebars: up to about 820mm wide
  • Max load: about 70 lb (32 kg)

Most normal mountain bikes are well inside that. Check your pedals though, some chunky flats might be close.

Verdict

Super happy with these. The bikes are off the floor, the paint stays clean, and there’s actually room to walk around the Jeep now. Simple install, solid hardware, and they look clean on the wall. If your garage has bikes leaning everywhere, this is one of the cheapest upgrades that makes the biggest difference.